Possible connection of blocks to 0,0
Moderators: SDS, support, admin
Possible connection of blocks to 0,0
I have been using the tool for many years and I am now in v15. Attached is a screenshot of a map where some entities (which may be inserted blocks) seem to be connected to 0,0. The erroneous lines are hightlighted in yellow. These lines do not show up in the DWG.
I did not create the map and I am not sure what these entities are. I tried exporting the map to older DWG/DXF formats, but the problem persists. I can share the DWG map itself by private message.
I did not create the map and I am not sure what these entities are. I tried exporting the map to older DWG/DXF formats, but the problem persists. I can share the DWG map itself by private message.
Re: Possible connection of blocks to 0,0
Hello!
Thanks for contacting us.
Could you please send me an e-mail to surkova@cadsofttools.com ?
Do not forget to specify:
- The name and the full title of the library
- The file you're working with
-The screenshot illustrating the issue.
Thanks in advance!
Thanks for contacting us.
Could you please send me an e-mail to surkova@cadsofttools.com ?
Do not forget to specify:
- The name and the full title of the library
- The file you're working with
-The screenshot illustrating the issue.
Thanks in advance!
Technical Support E-mail: support@cadsofttools.com
Chat support on Skype: cadsofttools.support
Chat support on Skype: cadsofttools.support