Cadview for TC - DWF: high memory load is not given free

[Peter]

Hi
relating on the Chat with Andrey today you can see the following problems in this screencast:

a) "Cancel" (Abbrechen), button on right lower corner is without function when loading
b) heavy RAM-load ("out of memory" or nearly out of memory) is not given free when the lister is closed. Low RAM-usage is OK, high usage not.

https://autode.sk/2BHprmV

Win 64
TC 32 bit
Cadview 14.0.0.2

Find attached the DWF used. It's from Autodesk Samples.

[support]

Hi Peter,

It seems there was some problem in the process of attaching your DWF file, could you please reattach it or send it to our e-mail, info@cadsofttools.com?

Thanks

Andrei

[Peter]

I tried to reattached the file to first posting - same problem: HTTP error ..
I'llsend it with mail.

Opening the same file with Win 10 / TC 9.21a 32bit / Cadview 9 needs 2-3 seconds, 420 MB RAM - and the RAM is free again when the viewer is closed. So something happened with Cadview between version 9 and version 14.

[support]

Opening the same file with Win 10 / TC 9.21a 32bit / Cadview 9 needs 2-3 seconds, 420 MB RAM - and the RAM is free again when the viewer is closed.

For your information, CADView 14.0.0.1 also works correctly in this case.

Mikhail

[Peter]

but I have 14.0.0.3 and the screencast above show how it works ...

What to do now?

[support]

but I have 14.0.0.3 and the screencast above show how it works ...

What to do now?

You have to wait for a fixed version. In the meantime, you may use version 14.0.0.1.

Mikhail